What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
13.06.2025 13:11

But… the neutral is now “floating” because of the 1 ohm resistance.
a photo is worth a thousand words.
The bolt then partially travels down the line to your home.
What is your biggest mistake or regret?
This one hit behind the barn.
The other is “what does a “fuse” do?”
At least they know the answer if they wanted it.
This is where the MOV conducts again, and dissipated the energy.
It seems Mohan does not understand the difference between a comment and an Answer.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
How can someone in your family purposely try to destroy your reputation?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
But it can get overloaded, and no longer works.
2024–10–10[John johnson John Johnson ]
These Diabetes Drugs Are Finding New Life as an Antiaging Hack - WSJ
These are simplified answers to the original question, and does not change anything I wrote above.
What is lightning?
He then describes Rainy Season and Lightning.
What was the craziest place that you had sex with someone in public?
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
(Dc diagram shown, AC is similar).
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
How do you find out who your handler is as a targeted individual?
This is the picture of an electronic coil of wire wound around a core of magnetic material.
This is 'the assistant's answer'
There are three different concepts here that are getting confused.
He then asserts :
Now when you have a certain ac resistance, then a current flows in a loop.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Is it true that most women like alpha males?
What does a fuse do?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
One is “what exactly is in a ‘surge protector’ ? ”
Fervo Energy lands $206M in financing to build massive geothermal power plant - TechCrunch
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
These devices are installed between the “hot” and “neutral” and protective ground.
but this device (an Inductor) … impedes the rapid changes in the current.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
eight
Because the load is inductive, the current lags the voltage.(by a bit).
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
[old diagram got deleted by accident]
An AC voltage/ current source, and an ac inductive load.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
The MOV will conduct when the voltage exceeds 50% of line voltage.
It also is a device that limits the change in current flow.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
So, the voltage could go up to 500 volts, and the fuse will not open up.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
the problem then depends on "how fast does the fuse operate?".
Edit 2024–10.
A circuit breaker is similar, but is resettable.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Barnstars:
but I think this circuit , shows a few more pieces.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
He then describes the function of a fuse.
nine
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
I post the exact comment here.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
2024–10–14 [Omar Gharbi Omar Gharbi ]
There are two important concepts here.
At one ohm, the resistor has a maximum of 1 watt power.
This device then solves the entire problem.
In schematic diagrams this is the symbol for a fuse:
so, what happens?
One
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
First Sentence:
The third is lightning and “how it gets conducted into a home.”
For this case there are devices called Metal oxide varistors (MOV).
2024–10–16 [ OO OLAOYE OYEBODE ]
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
[image of Common-mode choke]
what exactly is a ‘surge’ protector?
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Upvotes:
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Here is a simplified AC power diagram.
A fuse is a non-resetable over current circuit protector.